Round concrete pad calculator

SLABSET
VOLUME0.00includes 10% wastage
TO ORDER0 Bags (20kg) or 0.0 m3 Premix
To order
0.00
Inputs
ShapeRound pad
Diameter0 mm
Thickness0 mm
Wastage+10%
Estimated cost
Recommended: Enter dimensions to estimate cost.
Individual bags
0 × 20 kg · 0 × 30 kg
Ready-mix delivery
0.0 m³ + delivery (ex pump)

Typical metro prices in Australia. Confirm with your local supplier before ordering.

Materials & weight
Reinforcing mesh0 sheets
Formwork edge0.0 m
Concrete weight0.00 t
How it's calculated

Concrete is sold by volume in m³. Measure the space, work out its volume, add wastage, then convert to individual bags or a premix order.

Wastage: sites lose concrete to spillage and uneven ground. 10% is standard; raise it for rough ground, lower it for tidy formwork.

Bags or premix: a 20 kg bag yields ≈ 0.0098 m³ (~102 bags/m³). Premix sells in 0.1 m³ steps; below 0.5 m³ bags usually avoid short-load fees.

About

Round pads (water tank bases, hot tub pads, circular landings) are flat cylinders: π × radius² × thickness. Enter diameter and thickness in millimetres; a 2.4 m tank pad at 100 mm is about 0.45 m³.

Tank pads carry real load: check your tank supplier's minimum thickness and mesh requirements. SlabSet estimates mesh sheets and the circular formwork edge length for you.

FAQ

How much wastage should I add?

10% is a normal starting point. Use less for tidy formwork and more for rough ground, uneven excavation or over-dig.

Should I order bags or premix?

Ready-mix is cheaper per cubic metre, but delivery and short-load fees make small deliveries poor value: suppliers charge extra below about 0.5 m³. Bags cost more per m³ but scale down to any size. The switchover is roughly 0.5 m³: below it, order bags; above it, book the truck.

Does this replace a builder or engineer?

No. Use SlabSet for estimating, then confirm quantities, grade and reinforcement before ordering.

Other calculators

Estimates only. Confirm quantities and prices with your supplier.

SlabSet · Metric Concrete Calculator · designed in Australia · Terms · Privacy · Contact